http://www.newimageinc.com/alpine-pdx/
Problem with 12 "Alpine Type X and Alpine PDX 1100 Mono?
I have a 12 "type X with a 1,100 PDX mono amplifier with a power Acoustik 5.0f condenser, I have 4 gauge wires for power and land and I have a 4 ohm cable. if the sub-samples in the past half I realize the inside of the subregion inconsistently starts sparks and short and I have to turn off the car and turn back to get it to strike again. I noticed this because I have a 3 / 8 "Plexiglas back in my box. Why should this be happening?
I have the same setup on my car and when I arrived I did 6 x type subs fly back to back, the problem is that the voice coil wound type x is so strong that you have to play at low volumes of 15-20 hours to allow it to burn on. ml-first guy was doing exactly what Also, if you pull it out of the box and look down the back you'll see what looks like a little fur ball on the pole, which is really the voice coil has started to arrive without do submarines have 1 year warranty on them so you should be able to take back and exchange it for a new one, if the usual stock exchange because still works just turn the switch on the amplifier gain to the level of 1 volt and crank blow.when gain and to get a new one just remember to break and a subgroup will be responsible for all
|
|
Alpine PDX-5 – Amplifier – 4-channel plus Mono-power $342.00 5-channel car amplifier 75 watts RMS x 4 + 300 watts RMS x 1 at 4 or 2 ohms 150 watts RMS x 2 + 300 watts RMS x 1 in bridged mode (4-ohm stable in bridged mode) CEA-2006 compliant Stackable installation design with front-panel controls Variable high- and low-pass filters (30-400 Hz, 12 dB/octave) Quick-connect speaker connectors Class-D amplifier design MOSFET power and output stages Fuse rating:… |
|
|
Alpine PDX F4 – Amplifier – 4-channel $289.50 4-Channel Power Density Digital Amplifier, 100 watts x 4 chan @ 2 ohms, Total RMS: 400 watts, Signal-to-Noise Ratio: 76dBA, Switch-Mode Digital Topology, CEA-2006 Compliant Amplifier… |
|
|
Alpine PDX M6 – Amplifier – 1-channel $283.00 # mono subwoofer amplifier # 600 watts RMS x 1 at 4 ohms (600 watts RMS x 1 at 2 ohms) # CEA-2006 compliant # stackable installation design with front-panel controls # variable low-pass filter (50-400 Hz, 24 dB/octave) # switchable subsonic filter (off, 15 Hz, 30 HZ) # quick-connect speaker and power connectors # preamp-level inputs and outputs # Class-D amplifier design # MOSFET power and output … |
|
|
Alpine PDX F6 – Amplifier – 4-channel $417.98 4-channel car amplifier 150 watts RMS x 4 at 4 ohms (150 watts RMS x 4 at 2 ohms) 300 watts RMS x 2 in bridged mode (4-ohm stable in bridged mode) variable high- and low-pass filters (30-400 Hz, 12 dB/octave) Class-D amplifier design stackable installation design with front-panel controls quick-connect speaker and power connectors preamp-level inputs MOSFET power and output stages CEA-2006 compli… |